IoT JumpWay TTM ESP8266 Arduino Device

IoT JumpWay TTM ESP8266 Arduino Device
TechBubbleTechnologiesUK

TechBubbleTechnologiesUK
Creators of A.I. E-Commerce, TASS & retailAI
TechBubbleTechnologiesUK on Linkedin TechBubbleTechnologiesUK on YouTube TechBubbleTechnologiesUK on Facebook TechBubbleTechnologiesUK on Twitter

  

DESCRIPTION:

The TTM Device is a temperature and humidity sensor device created on an ESP8266 12F and uses the IoT JumpWay for its device to device communication. This is not yet a completed tutorial, but it should give you a good start as it is so far.

  

Introduction

The TTM Device is a temperature and humidity sensor device created on an ESP8266 12F and uses the IoT JumpWay for its device to device communication. Following this tutorial will

result in the breadboard TTM you see in the image below, in a future tutorial I will show you how to create the circuit shown on the right.

  

Required Software

  • Arduino IDE (I used 1.8.4)
  • IoTJumpWay
  • PubSubClient
  • ESP8266WiFi
  • ArduinoJson
  • DHT

  

Required Hardware etc

  • ESP8266 (I used 12F)
  • Breadboard
  • Wires
  • USB Programmer
  • Resistors
  • DHT11

  

IOT CONNECTIVITY:

The IoT connectivity is managed by the TechBubble IoT JumpWay, the TechBubble Technologies IoT PaaS which primarily, at this point, uses secure MQTT protocol. Rules can be set up that can be triggered by sensor values/warning messages/device status messages respond.

  

Before You Begin

There are a few tutorials that you should follow before beginning, especially if it is the first time you have used the TechBubble IoT JumpWay Developer Program. If you do not already have one, you will require a TechBubble IoT JumpWay Developer Program developer account, and some basics to be set up before you can start creating your IoT devices. Visit the IoT JumpWay Developer Program Docs on GitHub (5-10 minute read/setup) and check out the guides that take you through registration and setting up your Location Space, Zones, Devices and Applications (About 5 minutes read).

  

TTM Device Connection Credentials & Settings

Follow the TechBubble Technologies IoT JumpWay Developer Program (BETA) Location Application Doc to set up your IoT JumpWay Location Application.

  

Setup an IoT JumpWay Location Device for each IP camera you will be connecting to, and / or your Realsense camera. For this example, we only require the device ID for each camera, we will not be using the MQTT details for each camera as the application is capable of sending data on behalf of any device in its location. Follow the TechBubble Technologies IoT JumpWay Developer Program (BETA) Location Device Doc to set up your devices.

  

CONTINUE THIS TUTORIAL ON GITHUB...

To follow the the rest of this tutorial and set up your own TTM device, follow THIS LINK.

  

  

  

PROJECT INTRO:

The TTM Device is a temperature and humidity sensor device created on an ESP8266 12F and uses the IoT JumpWay for its device to device communication. This is not yet a completed tutorial, but it should give you a good start as it is so far.

  

IoT JumpWay TTM ESP8266 Arduino Device
 on GitHub

  

PROJECT VIDEOS

There are currently no videos for this project

  

Comments